Dolby Atmos 7.1.4 layout: where to place each speaker
Place the seat on your room plan and see which stretches of wall and ceiling zones each speaker of a Dolby Atmos 7.1.4 or 7.2.4 system can go in.
Drag the seat, or use the arrow keys. The colored bands are the walls where each speaker group can go; the rectangles are the ceiling zones.
- Front L/R · 22°–30°
- Center · 0°
- Side surrounds · 90°–110°
- Rear surrounds · 135°–150°
- Height speakers, on the ceiling · 30°–55°
Where each speaker goes
7.1.4
No conflicts
With the seat 3.80 m from the screen and a 2.70 m ceiling, the front speakers sit 1.54 to 2.19 m from the axis and the height speakers 1.12 to 2.77 m from the seat. Everything fits inside the room.
- Front L/R
- 22°–30°
- Left: front wall, 0.31–0.96 m from the left · Right: front wall, 4.04–4.69 m from the left
- Center
- 0°
- on the front wall, 2.50 m from the left, on the seat axis
- Side surrounds
- 90°–110°
- Left: left wall, 3.80–4.71 m from the front wall · Right: right wall, 3.80–4.71 m from the front wall
- Rear surrounds
- 135°–150°
- Left: back wall, 0.00–0.94 m from the left and left wall, 6.30–6.50 m from the front wall · Right: right wall, 6.30–6.50 m from the front wall and back wall, 4.06–5.00 m from the left
- Top front
- 30°–55°
- 1.12–2.77 m in front of the seat, 1.54 to 2.19 m from the axis, 1.60 m above your ears
- Top rear
- 30°–55°
- 1.12–2.77 m behind the seat, 1.54 to 2.19 m from the axis, 1.60 m above your ears
A Dolby Atmos room done right?
We integrate Dolby Atmos audio with the speaker layout and cabling documented from the plans. Tell us your room measurements and we will advise you.
Estimate for guidance. The final design is set by measuring the room on site.
Designing a Dolby Atmos system starts with a simple question: where does each speaker go? The answer depends on where you sit, because Dolby gives the ranges as angles measured from the seat. The calculator above turns them into stretches of wall and ceiling zones in your room: drag the seat on the plan and watch them move.
How to use the calculator
- Enter the room dimensions: width, length and ceiling height.
- Place the seat. Drag it on the plan, use the arrow keys, or type the distance from the screen and the sideways offset.
- Read where each group falls: the colored bands are the walls where each speaker can go and the rectangles are the ceiling zones for the height speakers. The measurements are below.
- Check the warnings. If something does not fit, the calculator says so and suggests what to move.
- Copy the link to share the result with whoever installs the system.
What a 7.1.4 is
A 7.1.4 is seven ear-level channels (front left and right, center, two side surrounds and two rear surrounds), one subwoofer and four ceiling speakers, two front and two rear. 7.2.4 adds a second subwoofer and the other speakers are placed the same way. This calculator covers those two formats; others, such as 5.1.2 or 7.1.2, have their own guidelines.
Dolby’s angles
The ranges in the Dolby Atmos installation guidelines for 7.1.4 are measured from the seat, with 0° pointing at the screen:
- Front left and right: 22° to 30° on each side of the seat axis.
- Center: 0°, on the seat axis.
- Side surrounds: 90° to 110°.
- Rear surrounds: 135° to 150°.
- Height speakers: at an elevation of 30° to 55° above the ear-level horizontal, in front of and behind the seat, in line with the front speakers.
They are ranges, not a single point: inside each band there is room to fit the speaker to your room.
An example: a 5 × 6.5 m room
Seat centered 3.80 m (12.5 ft) from the screen, a 2.70 m (8.9 ft) ceiling and ears at 1.10 m (3.6 ft). Wall positions are measured from the left wall (on the front and back walls) or from the front wall (on the side walls):
| Group | Angle | Where it goes |
|---|---|---|
| Front L/R | 22°–30° | Front wall: 0.31 to 0.96 m (1.0 to 3.1 ft) on the left and 4.04 to 4.69 m (13.3 to 15.4 ft) on the right |
| Center | 0° | Front wall, 2.50 m (8.2 ft) from the left |
| Side surrounds | 90°–110° | Side walls, 3.80 to 4.71 m (12.5 to 15.5 ft) from the front wall |
| Rear surrounds | 135°–150° | In the rear corners: side wall from 6.30 to 6.50 m (20.7 to 21.3 ft) and back wall up to 0.94 m (3.1 ft) from the corner |
| Top front | 30°–55° | Ceiling, 1.12 to 2.77 m (3.7 to 9.1 ft) in front of the seat and 1.54 to 2.19 m (5.1 to 7.2 ft) from the axis |
| Top rear | 30°–55° | Ceiling, 1.12 to 2.77 m (3.7 to 9.1 ft) behind the seat and 1.54 to 2.19 m (5.1 to 7.2 ft) from the axis |
Front speakers by seat distance
The front speakers sit at y · tan(angle) from the axis, with y the distance from the seat to the screen. The farther you sit, the wider they go:
| Seat distance | Distance from the axis (22°–30°) |
|---|---|
| 3.0 m (9.8 ft) | 1.21 – 1.73 m (4.0 – 5.7 ft) |
| 3.5 m (11.5 ft) | 1.41 – 2.02 m (4.6 – 6.6 ft) |
| 4.0 m (13.1 ft) | 1.62 – 2.31 m (5.3 – 7.6 ft) |
| 4.5 m (14.8 ft) | 1.82 – 2.60 m (6.0 – 8.5 ft) |
| 5.0 m (16.4 ft) | 2.02 – 2.89 m (6.6 – 9.5 ft) |
Height speakers by ceiling height
The horizontal distance from the seat is (ceiling − ears) / tan(elevation). With ears at 1.10 m (3.6 ft):
| Ceiling | Height above the ears | Distance from the seat (55°–30°) |
|---|---|---|
| 2.4 m (7.9 ft) | 1.30 m (4.3 ft) | 0.91 – 2.25 m (3.0 – 7.4 ft) |
| 2.7 m (8.9 ft) | 1.60 m (5.2 ft) | 1.12 – 2.77 m (3.7 – 9.1 ft) |
| 3.0 m (9.8 ft) | 1.90 m (6.2 ft) | 1.33 – 3.29 m (4.4 – 10.8 ft) |
| 3.5 m (11.5 ft) | 2.40 m (7.9 ft) | 1.68 – 4.16 m (5.5 – 13.6 ft) |
A higher ceiling pushes the height speakers away from the seat. If the room is not long enough, the zone runs out through the front or the back wall, and the calculator warns you.
What the calculator warns about
- The front speaker lands on the side wall. If the seat is far to one side, or far from the screen in a narrow room, the 22° to 30° angle reaches the side wall before the front wall. Center the seat or move it closer to the screen.
- The height speakers do not fit. With high ceilings or short rooms, the 30° to 55° zones run out in front of or behind the seat. Move the seat away from or closer to the screen, or mount the height speakers lower.
- Seat off the axis. It works, but the room is no longer symmetrical around the speakers: Dolby measures the angles from the seat.
What else matters
- Height of the ear-level speakers. The calculator places the positions in plan; the height of each speaker depends on the screen and the design of the room.
- Subwoofers. Their placement is decided more by the room modes than by angles. Work them out in the room acoustics calculator.
- In-wall and in-ceiling speakers. The positions are the same for flush-mounted speakers; check that there is space for the cabling and the structure.
- More than one seat. The calculator uses a single reference seat. With several rows, the main row sets the reference.
How it is calculated
- Rays from the seat: with the seat at
(x, y)(the front wall aty = 0), the ray at angleθleaves in the direction(sin θ, −cos θ). The wall point is the first intersection with the room perimeter. - Wall bands: the stretches of wall between the rays of the smaller and the larger angle of each group. If they wrap around a corner, both walls are shown.
- Front speakers: distance from the axis
y · tan(θ), withθfrom 22° to 30°. - Height speakers: horizontal distance in front of or behind the seat
(ceiling − ears) / tan(elevation), with elevation from 30° to 55°, and the same lateral distance as the front speakers. - Warnings: a ceiling zone is flagged as clipped if it loses more than 10% of its depth inside the room.
The results are a guide to positions: confirm the design with whoever installs the system.
Frequently asked questions
What is the difference between 7.1.4 and 7.2.4?
The 7.2.4 has a second subwoofer. The other speakers are placed the same way as in a 7.1.4.
Where do I put the side surrounds?
On the side walls, between 90° and 110° from the seat. With the seat 12.5 ft (3.80 m) from the screen in a 16.4 ft (5 m) wide room, that is 12.5 to 15.5 ft (3.80 to 4.71 m) from the front wall.
What if my ceiling is very high?
The height speakers move away from the seat: at 11.5 ft (3.5 m), between 5.5 and 13.6 ft (1.68 and 4.16 m). If the room is not long enough, mount the height speakers lower or move the seat.
Does it work for 5.1.2 or 7.1.2?
No. This calculator covers 7.1.4 and 7.2.4. Other formats have their own guidelines.
Want a Dolby Atmos room done right?
At DomuLab we integrate Dolby Atmos audio with the speaker layout and cabling documented from the plans. If you already have your room measurements, tell us and we will advise you. For the full picture, read the guide to home theater with Dolby Atmos and our home theater service.





